| Step 1 |
[lo res - 39 K][high res - 237 K] | Clean the chamber of the tool by inserting the chamber cleaning brush (R003) into the chamber. Put the handle of the brush through the bore siting hole first, then attach a drill to the handle section of the brush. Spray the brush with a non-petroleum solvent such as electric motor and contact cleaner. Do not use an oil-based solvent since oil will attract dirt. Scrub the chamber with the brush for 4-5 minutes to remove the burnt carbons. |
| [Back to top] |
|
| Step 2 |
[lo res - 19 K][high res - 101 K] | The bushing holes may also be cleaned with the chamber cleaning brush. |
| [Back to top] |
|
| Step 3 |
[lo res - 42 K][high res - 257 K] | The tool and all parts should be cleaned with a non-petroleum solvent and a brush to remove dirt, oil and grease. Proper and complete cleaning is essential prior to reassembly. |
| [Back to top] |
|